1-6 of 6
Keywords: finishing
Close
Follow your search
Access your saved searches in your account

Would you like to receive an alert when new items match your search?
Close Modal
Sort by
Journal Articles
Article Type: Research Papers
J. Manuf. Sci. Eng. February 2011, 133(1): 011007.
Published Online: January 31, 2011
... value 0.12837, then a reduced TOC m can be obtained. It is also realized that if the TOC m can be kept lower than the critical DOC ( DOC c r ) , then ductile finishing of brittle materials can be achieved. The above phenomenon has been substantiated by experimental findings while machining a hard...
Journal Articles
Article Type: Research Papers
J. Manuf. Sci. Eng. December 2010, 132(6): 061006.
Published Online: November 1, 2010
.... Through our extensive review, it was discovered that there are five key elements to a reliable integrated rapid manufacturing system: process planning software, motion system, control system, unit manufacturing process, and a finishing process. By studying the manner in which all other systems have been...
Journal Articles
Article Type: Research Papers
J. Manuf. Sci. Eng. February 2009, 131(1): 011001.
Published Online: December 4, 2008
...Dongdong Zhang; Pinghai Yang; Xiaoping Qian This paper presents an approach for generating curvature-adaptive finishing tool paths with bounded error directly from massive point data in three-axis computer numerical control (CNC) milling. This approach uses the moving least-squares (MLS) surface...
Journal Articles
Article Type: Research Papers
J. Manuf. Sci. Eng. February 2008, 130(1): 011002.
Published Online: January 16, 2008
...Jia Tao; Albert J. Shih; Jun Ni This study investigates the dry and near-dry electrical discharge machining (EDM) milling to achieve a high material removal rate (MRR) and fine surface finish for roughing and finishing operations, respectively. Dry EDM uses gas and near-dry EDM applies a liquid-gas...
Journal Articles
Article Type: Technical Papers
J. Manuf. Sci. Eng. December 2007, 129(6): 1069–1079.
Published Online: March 27, 2007
... in cutting loads on the tool, resulting in geometric inaccuracy of the machined workpiece surface. This paper presents an algorithm to generate a new offset tool path, such that the cutting engagement is regulated at a desired level over the finishing path. The key idea of the proposed algorithm...
Journal Articles
Article Type: Technical Papers
J. Manuf. Sci. Eng. December 2007, 129(6): 1045–1059.
Published Online: March 13, 2007
...M. Barletta; D. Ceccarelli; S. Guarino; V. Tagliaferri The relatively new technique of fluidized bed assisted abrasive jet machining (FB-AJM) is applied to finishing the inner surfaces of tubular Inconel 718 components. The effects of abrasive size, jet pressure, and machining cycle were evaluated...